IP to Coaxial Converter, Eoc Master and Slave

1.Product Introduction
1 Channel ip to coaxial converter adopts coaxial cable (or two-wire cable)  to transmit megapixel HD network videos.It support ip cameras cascaded connecting by T connector over one coaixal cable more than to 2KM.
It can solve the problem of IP camera's short transmission distance with advantages of easy installation,  labor and equipment cost saving, and no need of fiber splicing any more.
2.Product Features
Long Communication Distance
The transmission distance can reach to 2KM or more without any repeater, which greatly helps at network cabling and also avoids the problem that network construction must be equipped with Ethernet switches when transmission distance is over 100M.For SVY/SYWV75-5 cable, it can keep the TCP/IP throughput no less than 30Mbps while transmission distance up to 2000M.
Strong Extension Ability
No need of rewiring if need to increase the node.A coaxial cable can support max.10-channel megapixel HD video, alarm, intercom, control signal be transmitted at the same time.Ans both Ethernet and Analog systems are single point to single point.
High Performance
Support 10-ch HD video transmission at the same time, and with strong anti-interference function, can adapt to all kinds of wiring environment, can be used for road, bridge, elevator, tunnel and other environment.
Easy Installation
Plug and play, no need of software and hardware settings, and the transmitting and receiving devices are the same.It can upgrade existing common cameras into megapixel HD cameras without wire change.
Low Cost
Use low cost cable to transmit.
Quality Assurance
Three-stage lightning-proof design with quality assurance.Industrial design, 100% aging testing, to ensure product quality.

3.Product Appearance
Connection Indicator (Coaxial):
Connection indicator ON means the cable and equipment is working properly.Otherwise, the connection indicator will be OFF.
Network Indicator (LAN):
Network indicator lights:Means product and computer IP camera, NVR or network switch is connected well, otherwise, the connection is not normal.
Communication Button:
Communication link control Master/Slave selection.When switch the button to left position, the device will be Slave, and it will be Master when switch the button to right position.A network must have one and only one master device, but can have multiple slave devices.
Note:If the device switch the "Master/Slave" button under power on state , need to power off and restart it.
4.Transmission Parameters