Product Description
Compact tubeless design and small size.
Low weight without sacrificing performance.
Sophisticated optical system with high-quality imaging.
Suitable for pistols, short barrel and large caliber guns. Easy mounting with you own optional mount adapter Large field of view due to its low magnification
Parallax is free at 50 yards.
Low power consumption for long battery life
Automatically adjust the brightness of the aiming dot to varying light levels in
the surroundings  
 
BATTERY                        
RDP- II Mini Sight is powered by one 3V lithium battery (CR2032 or equivalent). Insert the battery cavity on the underside of the housing so that the battery label identifying the positive pole is visible. For battery replacement, take out the exhausted battery by placing the Allen key in the notch located on the right-hand side as see from the bottom.

POWER-SAVING                    
The device does not contain a separate ON/OFF switch. To operate the electronic circuit in the power-saving mode, attach the cover. You may also store the device in a lightproof box to achieve the same power-saving effect thus allowing operation over a longer period.

MOUNTING  
Mounting the sight requires a separate mount adapter for your respective gun. The underside of the sight housing contains flat bores for the accommodation of alignment pins providing defined position. Using the hexagon socket-head screws and the Allen key provided fasten the sight on the mount adapter. Then, tighten the mount adapter on the gun.
 
ELEVATION AND WINDAGE ADJUSTMENT  
The sight contains separate controls for elevation and windage adjustment. To adjust the sight, turn the slotted screws using the provided adjusting wrench with attached scale and the screwdriver. Before every adjustment of elevation or windage, turn the thrust and clamp screws on the rear side of the sight to make sure to loosen the lock of the adjustment mechanism to avoid damage to it.

ZEROING                          
Adjust the point of impact using the provided scale disk with integrated screwdriver.Put the scale disk onto the elevation or windage adjustment screws. Use any edge on the sight as the reference line for the adjustment. The scale disk allows defined elevation and windage adjustment in both senses of rotation. Turn the adjustment screw clockwise results in downward or leftward shift of the aiming dot. After that, fasten the clamp screws.  
 
 
SCOPE OF DELIVERY            
2 countersunk screws M3x8 with hexagon socket head for installing the sight on the mounting plate
1 Allen key for tightening the fastening screws
1 screwdriver
1 adjusting wrench with scale disk specific for the sight
1 protective cap
1 Lithium battery 3 V, CR 2032
operating instruction