Winplus International Company Ltd.

We have our own strong and experienced R&D team in Ningbo Office, which can support us to accept not OEM order, but ODM order.

“Trust is good, but control is better”, in order to guarantee the quality manufacturing, We always have 3-4 QC employees in normal condition, which formerly worked in PSL or Pro QC.
Whatever the buyer arranges for inspection with the manufacturer before shipment or not, Winplus will arrange our quality control process as the following for every order.
IPI - Initial Production Inspection ,
For timely correction and improvements ,prior to the commencement of full production. Materials, components and first finished products are checked against the sealed samples before commencement of production.
DUPRO - During Production Inspection
In order to avoid last minute delays during final shipping inspection by identifying problems as they arise during the production process, thus allowing corrective action to be taken at an early stage.
Once the production has started, a senior Q.C. Engineer will check the complete production status, step by step, report the actual status as well as all short comings and non-conformances. At the same time the Q C engineer will recommend corrective action for improvements. The actual production status will be reported and all incoming materials will be checked for completeness and correctness. If applicable he’ll also check whether the improvement-corrections, as suggested in our Quality test on the pre-production sample were implemented. Further corrective actions, if needed, are advised.
FRI - Final Random Inspection
• This will be carried out once the merchandise is fully produced, packed and in all respects ready for the shipment or the final inspection from the clients, samples will be selected at random and checked against your specifications and according to "ANSI Z1.4-1970" (correspond to MIL standard 105 E).
Loading Supervision , In order to ensure that the products, which have been inspected, are also those being shipped. The containers are inspected for suitability and cleanliness and also that the products to be shipped are properly packed and loaded into the container. The loading process will be photo documented and finally the container will be sealed with shipping line seal. In cases where the container isn’t completely full, the consignment (LCO) will be accompanied to the shipping company warehouse.