HID Car Headlights, Automobile Lighting System

Product Description

We highly advise professional HID light kits installation.

1. Check the headlight housings to ensure they are not damaged.

2. Make sure the vehicle does not have any pre-existing electrical problems.

3. Vehicles with a single fuse for both lights must have a fuse at least 30 amps.

If there is one fuse per headlight, each fuse must be at least 20 amps.

4. Identify the ballast's positive and negative wires.

5. Never touch any bulb with your bare hands. If touched accidentally, use alcohol to clean the surface.

6. Before connecting the wires and harness, you must clean all connectors, especially the AMP connector. Make sure the installation is in A DUST FREE condition.

7. Do not look into the light directly when the HID is lit up to avoid visual hazards.

8. Please do not install the ballast, the igniter, and the connection wires close to the engine or places where water may penetrate to avoid any overheating or leakage. And donot open the ballast!

Step by Step Installation 1-2-3

Easy installation in general goes like 1-2-3-done as described below.

Step 1: After disconnecting power to the two headlamps and after removing the bulb access covers of the low beam, high beam or both bulb access covers, drill a small hole in the removed cover. The HID-Xenon bulb wire is passed through this hole for your headlamp upgrade. On the wire is a supplied adjustable tight rubber waterproof grommet to be fitted into the hole. Next, the HID-Xenon D2S/R bulb is fitted into the headlamp's base and locked into position via the factory locking device. No cutting of wiring is required on the installation.

Step 2: Reinstall the access panel and close it. Secure the small ballast to a convenient location in the motorbay.

Step 3: Finally attach power to the headlamp in the normal manner and the upgrade is completed. Headlamp realignment is recommended but only required if you have removed the headlamp during the upgrade which sometimes can be avoided (model and side dependant).

It takes about 1-2hours to complete the installation. No special tools are required. Normal handtools only.