32W 12V Yacht Flexible Amorphous Silicon Solar Module (LQF-32)

Product Description

32W 12V Yacht flexible amorphous silicon solar module
PRODUCT SPECIALITY
1. Product for Use
The flexible silicon thin film solar module for boat to use can change the sunlight into DC output directly, which can charge 12V rechargeable battery.

Small module for charging a battery of boat (LQF-5)
The module will produce 151wh of power on an average every week in sufficient sunshine. It can compensate the self-discharge of the battery automatically and reduce a risk of use for the battery.

Big module for charging a battery of boat (LQF-32)
The LQF-32 is a heavy duty power source that can provide approximately 977Wh of power on an average per week. After charging a battery completely, it will meet the requirements of lighting, radio, stereos, water pump and motor of operation. Using multiple LQF-32's to operate vehicle refrigeration.

Maximize your "quiet" time by reducing engine use for battery charging. The LQF-32 is the optimum standalone power source for people's vacation.

Note: The amount of calculation above is counted by the six (6) hours in standard irradiance per day. It can vary depending upon different areas.

INSTALLATION & APPLICATION:
CAUTION:
The solar modules produce electricity when exposed to light. The voltage form a single module is not considered hazardous, however, if modules are connected in series to increase voltage, the shock hazard increase. When working around the solar modules, batteries, and related electrical equipment, observe related industry standard and safety procedures.

1. INSTALLATION
1.1 SELECT THE BEST MOUNTING LOCATION
Deck, hatch, boom cover, RV awning or roof, and dash board are convenient locations that the places can receive sufficient sunlight throughout the daytime.
Also, the places should shed water.

1.2 MOUNT THE MODULES
Fasten the modules onto a surface or the top of a canvas with grommets on the modules. And lead the cable of the modules to battery nearby.

1.3 CONNECT THE MODULES TO BATTERY
Connect RED terminal to positive post of battery and BLACK terminal to negative post.
WARNING: Reverse connection to the battery will be a fire hazard. It will also damage your modules. Observe polarity carefully.
Disconnect the modules to battery if it not be in use for months.

2. APPLICATION
2.1 For the initial use, the output of the modules may be 15% to 20% higher than the rated value. This should be paid more attention so that avoid damage to the electrical appliances. Before use, make sure that the parameters of modules and electrical appliances must be matched each other.

2.2 You should concern that a surplus of voltage and current when choose related fuse, wire and electrical equipment. The ratings of voltage and current for electrical equipments should not be under1.5 multiply the ratings both of open circuit voltage and short circuit current for the solar modules.

More Product Features