Stainless Steel Pulp Tank, Pulp Tank, Pulp Water Tank, White Water Tank

The ingredient tank, also known as the mixing tank or ingredient bucket, has heating, automatic temperature control, insulation, and mixing functions; The advantages include fast heat transfer, adaptability to large temperature differences, and easy cleaning. Applied in industries such as food (dairy) products, pharmaceuticals, daily chemical products, beverages, oils, chemicals, pigments, etc. as intermediate buffering, liquid storage, mixing, blending equipment (in a state where materials can be evenly blended without heating, this equipment is economical and practical), heating, mixing, blending or sterilization treatment. Suitable for small and pilot scale use in units and research institutions without steam heat sources. And it can adopt a ground sealed structure or a temperature controlled structure according to the process requirements.
1. Capacity: 50L, 100L, 200L, 300L, 500L, 600L, 1000L to 5000L.
2. Heating method: Using an electric heating rod inserted into the jacket, heating evenly without any cold zone. Injecting thermal oil or water into the jacket as a heating medium generates heat energy to heat the material inside the tank.
3. Material heating temperature: ≤ 350 ºC; Material heating time: 20min to 90min (depending on process requirements).
4. Temperature control: The thermocouple is used to measure temperature and the temperature controller is connected to the radial measurement and control temperature (temperature difference ± ≤ 1 ° C), and the temperature of the material can be adjusted. The temperature controller is installed inside the electric control box, and the temperature transmission rod is inserted directly into the bottom of the tank, so that the temperature of the liquid can be indicated even when it is in a low position.
5. Tank body: The inner surface is polished with a mirror finish, with a roughness Ra ≤ 0.4 μ m.
6. Upper cover: It is a two leaf movable cover that is easy to clean, with mirror polished inner and outer surfaces (roughness Ra ≤ 0.4 μ m).
7. Inner tank bottom structure: processed into an R angle by spinning, welded and polished to the inner tank body without dead corners, and inclined at a 5 ° angle towards the discharge port for easy discharge of materials without retention.
8. Jacket form: Ground jacket, used to add thermal oil or water to achieve the purpose of heating and cooling during operation.
9. Warm material: filled with pearl cotton, rock wool or polyurethane casting foam, maintaining a temperature difference with the outside to achieve thermal insulation.
10. Surface treatment method for the outer shell: mirror polishing or 2B primary matte or 2B frosted matte treatment.
11. Mixing device: The top middle three are mixed, and the output shaft of the reducer is connected to the mixing blade shaft with a flexible sleeve for easy disassembly and cleaning.
12. Mixing speed: 15-120r/min (constant speed); Mixing blade forms: frame type, anchor type, blade type, turbine type, etc. (according to process requirements).
13. Equipment configuration: electrical control box, thermometer, liquid outlet, medium outlet (diameter, oil discharge), vent (oil overflow hole), etc.
14. Material: Inner tank body SUS304 or SUS316L; Clamp SUS304; The outer shell is made of SUS304.
15. The process openings of each outlet pipe and the welding points of the inner tank body are all rounded with a flanging process, which is smooth, easy to clean, and has no dead corners, and has a beautiful appearance.