Hot Water Hydronic Building Material Floor Heating System

5 way valve stainless steel manifold for solar heating system and floor heating system

 
-      Main body is of 1"BSP stainless steel main tube, center distance is 60mm, with excellent polished surface treatment. 
-      Supply manifold with balancing flow meters (0.5--5 l/min), 1/2" outlets,
Return manifold with manual valves with option for thermal actuators, protection caps, 1/2" outlets
-      Every set of products are 100% tested for press before they leave the factory, and ensure use of performance, big flow, small water resistance of every product. 
-      A pair of brackets 200mm or 210mm centering.
-      Each set is strictly QC tested, won't cause any leakage
-      Each set pre-assembled, in an inner box packing for easy carrying
-      Good quality, competitive price. (100% 304 material guranteed)
-      Specialized in Manufacturing and Supplying a wide range of  Manifold, OEM or ODM are welcome.


When fixing a manifold to timber studding or plaster board walls, it is recommended that fixing timber

is placed within the timber wall construction where the manifold fixing points are to be drilled and screwed.
this will ensure a secure fix for the manifold. Where this is not possible, suitable cavity fixings can be used.


Step 1 - Fix the manifold onto the wall using the fixing holes on the bracket and the plugs / screws provided.
It must be 650mm from the top of the EPS floor insulation to the top header and level.

Step 2 - Connect the 1" isolation valves to the top and bottom headers(same end) of the manifold.
To avoid leaks ensure that the fibre washers provided are positioned between the valve face and
the manifold prior to tightening the union nut.

Step 3 - The pipe retaining rail should be fixed approximately 175mm below the manifold and should be
trimmed to suit the size of the manifold. It is recommended that +150mm is added to the length of the
manifold. It is recommended that +150mm is added to the length of the rail over the length of the manifold.


Step 4 - Place the fixing lugs onto the rail, push them tight against either side of the pipe (now protected by the corrugated sleeve) and screw them tight, once in position.