Jcsf V Vertical Turbine Ultrafine Calcium Carbonate Powder Air Classifier

High Quality Turbo-rotor Mill

Summarize of JCSF Vertical Turbine Ultra-fine Classifier:
        The balance between the centrifugal force generated by the rotating turbine and the centripetal force created by the air.The material to be graded is sucked into the grading chamber by the high-pressure negative pressure suction system through a feeder,and is subjected to strong and powerful centrifugal force field near the volute casing and the staged turbine. After satisfying the requirements,the fine powder is sucked out of the grading impeller and collected by the collecting device. Then drop the lower box, here due to the impact of the second into the air was dispersed again, the fine powder mixed with the coarse powder again with the air into the classification zone, the coarse material along the inner wall is col-lected by the off-fan. As the turbine and the uppertank body with air seal, making the sealing effect is very superior,more uniform particle size.By adjusting the speed of the drive motor and the amount of secondary air intake,the best grading effect can be obtained.

Overview of JCSF Vertical Turbine Ultra-fine Classifier::
        JCSF-V high-efficiency turbine super-micro classifier is suitable for low to medium hardness material classifier of superfine classifying equipment that our company is based on digesting and absorbing foreign advanced powder technology. The performance indicators have reached the international similar model standard. The machine with secondary air inlet and high-precision turbine,which obtain the fine materials of up to 8 microns, and rotors with special materials can be classified high hardness materials,widely used in chemical,pharmaceutical,food, non-metallic mineral industries such as the classification of ultrafine powder particles, except iron, selected, etc. Performance feature:

Performance characteristics:
• Dry material air classifier adopts turbine classification principle, with secondary air intake and stepless variable speed classification turbine, and adopts air flow sealing device, high classification accuracy, wide classification range, and can adjust the finished product particle size between 3~1SOum. Under normal circumstances, the ultrafine powder with less than Sum and more than 97% content can be obtained.
• The blades of the graded impeller are made of special high-strength wear-resistant materials, which greatly improves the stability of high-speed operation and has a longer service life. When dealing with viscous and cohesive materials, the deposition of micro-powder in the discharge pipe is greatly reduced;
• JCSF-V adopts vertical grading wheel, all-round discharge around, so the processing capacity is large;
JCSF-H adopts horizontal classification wheel, which can obtain higher speed, so the classification accuracy is high.

· The biggest feature of this machine is that the material is fed from the center of the crushing disc. Compared with other shredders, it can obtain greater acceleration and crushing kinetic energy, and feed grain size is larger (≤50mm, the material can be added only after passing through the first-level roughing equipment);

· The extended classification chamber enables the crushed material to enter the centrifugal classification area after sufficient gravity classification, which can obtain better fineness and has absolute advantages in controlling large particles;

· When crushing materials with high moisture content, the drying effect is good because the materials after crushing can enter the classification area after a longer classification chamber;

· Using "stone beating stone principle" to crush needle-like materials, the length-diameter ratio of finished products can be 15:1;

· The grinding block and gear ring are made of composite wear-resistant material with long service life;