Digital Corona Plasma Treatment

Specification
Model: FR50DR
Input voltage/frequency: AC220/230V± 10% 50/60Hz
Woring frequency: 22.5kHz
Output power: 600-1200W
Treating width: 30-50mm(rotate)
Gas: 0.4Mpa no water

Introduction

1. Industrial use of smart chip control processing, the plasma output power canbe precisely regulated and setting.
2. Set power can be remember until the next boot(not affected power failures).
3. Power would be smart after the creation of precise lock, without external voltage fluctuation and working conditions of influence, thus the treatment effect of plasma stabblity, and also reduced the passive manual intervention
4. LCD function, Set power display, the actual dynamic power display.
Power of state data shows: Frequency, mediun voltage current, real time power supply voltage and so on.
Machine warning display
5. Online ready to ok the external signal input. External equipment to confirm the site is ready, the, machine can only start the working
Noted: This signal can be directly shorted wiring end, as the feature by default
6. In addition to this machine from the panel buttons take the initiative to do"start" and "suspension"of the active control mode the machine. Also has an external control input of the passive control mode.
7. The machine have many type of automatic monitoring and waring capablities.
8. The machine can according the surface treatment request, Pressure on the plasma jet continuously adjustable.
9. The machine can according to the customer surface treatment function request, equipped with a variety of plasama injection nozzle.
10. The interior design of this machine with a variety of interfaces be reserved, you can according to customer requirements, combined with the actual production line of on-line installation of variety of automatic control functions
Noted: Must be according to customers request commission.
11. One unit can combine many plasma generators and match more nozzles, according to customer's requirments.