High Performance 0.8L Peltier Thermoelectric Semiconductor Water Cooling Chiller Tec Cooler

Product Characteristic
 
      Water Cooling Chiller  used to cool or heat a liquid or gas flowing through a heat sink. Thermoelectric liquid heat sink is designed for a recycling system. The heat is absorbed by the liquid heat sink, pumped through the thermoelectric modules, and then dissipated to the air by an air heat sink.
 
Product Specification 
Proudct Note
 
1, When use self-tapping screws to work with water cooler, must avoid the melt surface ice at the bottom of the gallbladder, otherwise, once the self tapping screw twist into the melt surface, can cause leakage phenomenon. Melt surface position dimensions as shown in figure (ice bile installed at the bottom of the aperture Φ2.5 or 3.0 Φ; fixed screw choose 4 x 12 ba tapping screw).
 
2, The center of the water cooler vents must be at the center of the backboard of the water fountain, the fan side of the water   is 96mm high.
 
3,Don't make the fan of water cooler cover water machine back contact directly, and must be set by the fan cover and add a rubber horn ring or sponge coil and water cooler back contact.
 
4, All the silicone tube, set into the water cooler inlet and outlet pipe, drainage pipe, must be fitting, and sets of not less than 10 mm in length, and nylon cable tie or card to lock ring (note: silicone tube before assembly, application of boiling water for 30 minutes).