High Speed PVC Pulverizer Miller Machine

The main structure is equipped with rolling bearings to support the main shaft at both ends, and the motor is driven by the belt to drive the main shaft and the turbine fastened on the main shaft to rotate at a high speed. The grinding blocks on the turbine and the screen ring form a reasonable and compact structure. They are the raw materials entering the machine. The tight friction and the impact of the air flow in the rotating air flow occur on the inner side of the blade of the turbine, and in the blade and the grinding block. In the gap between them, re-grinding is carried out. During this process, the turbine sucks in a large amount of air, which serves the purpose of cooling the machine abrasive and conveying the fine powder. The fineness of the pulverization actually obtained depends on the predetermined material, the shape and size of the mesh, and the throughput of the material and air. The product is compact and reasonable in structure, moderate in volume, low in energy consumption, high in efficiency, stable in rotation, low in noise, reliable in sealing, free from dust pollution, good in self-cooling function, simple in installation, easy to disassemble and easy to repair, convenient for changing and replacing parts, etc. Features %0A Compared with similar mills, the output is greatly improved under the same power (increased production by 20% 25-50% 25), saving energy. %0A adds a dust collecting device, which effectively reduces dust pollution. The %20 shut-off fan discharge reduces the labor intensity of the operator. %20 main door can be opened for easy access and tooling

The use of feng shui double cooling, better to reduce the working temperature inside the machine, the material is not easy to deform, but also conducive to the grinding of heat-sensitive plastics, can be part of PE, ABS grinding. The correct way of operation:
Familiar with the contents of the manual and the function of the electrical button. The direction of rotation of the main unit must conform to the direction of the arrow marked on the belt cover line. Reverse rotation is strictly prohibited.
Start the fan before starting the machine (pay attention to the steering). After the normal operation, start the main machine to reach the normal speed and start feeding.
Start the automatic feeding machine at the beginning of production, as long as the material can go in, and then slowly accelerate the feeding machine. The load condition of the machine is generally around 80 amps, because the ammeter on the electric control cabinet is measured by 4 parallel Therefore, the total current value is 90A and the current swings between 65-80A during normal operation.
Material selection requirements: The material value should not exceed 8 mm. Do not mix metal and stone into the machine to avoid intensifying the grinding and damage of the cutter plate.
If there is abnormal noise during operation, stop immediately, open the door cover to check, and after troubleshooting, adjust the cutter clearance to continue production.
Turn off the automatic feeder before shutting down, make sure the main unit has no material, then turn off the main machine or vibrating screen, and finally turn off the fan.

Techinical data of PVC pulverizer miller machine: