Zy 11b2 Diamond Grinding Wheels

Diamond resin grinding wheel has a good polishing effect, grinding wheel sharp, not easy to plug, the specific characteristics are as follows:
1.High grinding efficiency, while the grinding wheel consumption is relatively slow;
2. Good self-sharpening, small heat during grinding, not easy to clog, reducing the phenomenon of work burn during grinding;
3. The grinding wheel has a certain elasticity, which is conducive to improving the roughness of the workpiece surface, mainly used for fine grinding, semi-fine grinding, knife grinding, polishing and other processes;
4. Diamond resin grinding wheel is low temperature curing, short production cycle, equipment and supply process is relatively simple; Because the resin has fluidity, it is easy to form the grinding wheel with complex surface.
When using resin grinding wheel, be sure to follow the following rules, otherwise it will not only affect the quality of grinding, and may even cause more serious consequences.
1, the resin grinding wheel must check whether the product has cracks and dumb sound before use, if it can not be used;
2, grinding wheel speed shall not exceed the safety line speed;
3, should not work in the end of the grinding wheel;
4, when the grinding wheel is processing the workpiece, do not push the workpiece with a lever to increase the pressure of the grinding wheel;
5. Professional dressing tools should be used when dressing the grinding wheel, and the operator must wear protective equipment;
6, grinding should be the correct choice of coolant. If coolant is not used, there must be a dust-proof device;
7. The center hole of the grinding wheel and the center shaft of the grinding wheel must be matched, otherwise it cannot be used;
8. The shape and size of the clamping flange on both sides of the resin grinding wheel must be consistent; Diameter must meet the requirements, both sides must have grooves;
9. When installing and fixing, the tightness should be moderate. After the installation is complete, start the machine and leave it idle for about one minute.
10. The pressure given during grinding and use should be uniform. When the grinding wheel adjusts and rotates, it is forbidden to collide with the workpiece violently. The feed should be gradual, and the contact surface between the grinding wheel and the workpiece should be reduced when cutting the large-diameter workpiece.