Hydraulic Splitting Bar Lz-P110

Brief introduction of Lizhi brand hydraulic splitting rod
The splitting bar consists of a 1m long cylinder block with a bursting force of up to 5000T and 7-10 pistons. It is equipped with German and Korean technology. It has been carefully designed by engineers, with precise structural processing, ingenious oil seals, and imported zero. The accessories are cast with a beautiful appearance, stable performance, high efficiency, simple operation, high-end quality new hydraulic static explosion principle, large quarrying machinery.
Lizhi brand hydraulic splitting bar high pressure oil pipe
Among all hydraulic equipment, the hydraulic oil pipe is the traffic anchor for the entire hydraulic system. It is responsible for the transmission of hydraulic oil and has a high compressive strength requirement. However, the quality of the hydraulic tubing may cause a tube explosion hazard, which may cause physical damage to the worker's master, and there are certain safety hazards. Inferior hydraulic tubing should be rejected. The high-pressure fuel pipe used by Lizhi Company has the highest pressure resistance of 350Mpa, while the Lizhi brand hydraulic splitting rod only needs 120Mpa. The oil pipe is mainly composed of an inner rubber layer, a middle rubber layer, a 2, 4, 6 layer steel wire wound layer and an outer rubber layer. The inner rubber layer has the function of subjecting the conveying medium to pressure and protecting the steel wire from erosion, and the outer rubber layer protects the steel wire from damage, and the steel wire layer is a reinforcing material for the skeleton material. Each high-pressure fuel pipe is factory tested. Only after passing the inspection, will it be put into the market. High safety factor, can be used with confidence.
Lizhi brand splitting bar operation process
    1 First put the rod into the 110mm hole, make sure that the piston is all placed.
    2 Start the power supply, change the manual reversing valve to the oil pipe, start to extend the oil inlet piston, generate thrust in the direction of the air surface in the hole, and there will be a crack path on the rock surface.
    3 The hydraulic oil gauge shows that when the hydraulic pressure reaches 100Mpa, it means the work is completed.
4 Switch the manual valve to the opposite direction, the piston shrinks to the initial state, and is manually raised from the split hole.
Hydraulic splitting bar for on-site punching requirements
"1" drilling rig, 110mm diameter hole, the shallowest depth of the hole is 1.2 meters (the depth can not be shallow) the rod distance is 0.8 meters, and the distance from the air surface is 1 meter. This is for the granite mining standard (depending on the rock quality) ;
"2" drilling rig, diameter 130mm hole, the hole depth is about 1.5 meters, the rod distance is 1.5 meters to 2 meters, and the distance from the air surface is 1 meter to 1.5 meters, which is based on the granite mining standard (according to rock rock quality) set);
"3" drilling rig, 150mm diameter hole, the hole depth is about 1.5 meters, the rod distance is 2 meters to 2.5 meters, and the distance from the air surface is 1 meter to 1.5 meters, which is based on the granite mining standard (according to rock rock quality). set);